HTX-252 MANUAL PDF

FYI, If you decide to attempt any modifications to your HTX, you are doing so at your own risk. HTX Owners Manual HTX/Albrecht AE Service. Update*** I’m still doing this repair for those who may need it. Here are the specifics. I charge a flat fee of $35 which includes the new mic cord, the. Cat. No. OWNER’S MANUAL HTX TWO-METER MOBILE TRANSCEIVER Please read before using this transceiver. INTRODUCTION Your .

Author: Gardagami Tojakinos
Country: Djibouti
Language: English (Spanish)
Genre: Automotive
Published (Last): 3 October 2018
Pages: 184
PDF File Size: 7.88 Mb
ePub File Size: 17.50 Mb
ISBN: 352-9-34836-141-5
Downloads: 69038
Price: Free* [*Free Regsitration Required]
Uploader: Shaktimuro

Until it hears the sequence, the HTX does not pass any transmissions to the speaker. Just my opinion though, try it out for yourself! Remove the fuse from the holder, and slide the fuse out of the end connectors. I had to replace the microphone cable if I wanted to continue to htx252 the radio.

This selects the low power 10 watt setting. There have been a bunch of them showing up on Ebay thanks to them closing hundreds of RS stores and clearing them out.

Radio Shack HTX Microphone Cord Replacement |

Then press to select the desired menu option. To turn off the alert function, press F then ALT again.

  AL AQIDAH AL WASITHIYAH PDF

I settled for this one which can be purchased on ebay for around 15 bucks and free shipping. DTMF Memory 0 holds 7 digits. If I run across others with the same problem I will certainly refer them to you. Don’t show me this message again. The HTX displays rC and the currently set receive tone.

The factory default is 2 seconds. The power setting is saved when you store settings in memory.

This procedure clears all the information you have programmed into the transceiver. Understanding the Display—lists all display indicators and gives a brief explaination and notes the sections where the indicator is fully explained. Follow these steps to change the scan resume delay. The default range is Be sure LOCK is not on the display. The toughest part of this whole ordeal was reusing the stress relief on the microphone itself. Nor does it cover a product subjected to misuse or accidental damage.

The rubber coating on the cord dry rotted from years of sitting in the truck. Spurious and Harmonic Emissions Frequency Error. SE —do not resume scanning. When you tune to a frequency that is normally assigned for repeater use, the HTX automatically selects the correct input frequency if you turned on the AS option.

You might need to connect the red wire directly to the battery if you experience ignition noise. For example, if these sequences are assigned to a group: This procedure clears all stored information. Setting the Scanning Range. Clearing a Memory Channel.

  BENQ W500 MANUAL PDF

Once you do that, the transceiver tunes the primary frequency or memory location for 5 seconds. To restore the key tone, repeat the procedure. As far as the tips go, I used these and just picked the one that was the closest width to the solder pads in the microphone itself. A repeater is a station that receives a signal on one frequency the input frequency and then retransmits that signal on a differ- ent frequency the output frequency.

Your HTX is programmed with the default kHz frequency offset and direction for the 2-meter band.

Index of /k/kb1uif/downloads/Service & User Manuals/Radio Shack/HTX-252

Using another type fuse, or defeating the fuse protection, htx-2252 damage your vehicle or your HTX You can see how the rubber broke in segments and caused added stress to the conductors inside. Page 8 Start studying for the license exams.

Low is about 10 watts, and high is about 45 watts.